A Collection of Thoughts on Custom Fabrication

• Teensy++ mentioned

• Had used
• Next time would powder coat it

• might have to break it up into pieces small enough for the printer to print
• acetone “welds” the separate pieces together

Used the serviceable switch pattern

  I used 1N4148 diodes and bent all them together and put them like this to
  solder them. The last row was a bit more difficult. Don't heat the diodes too
  long and of course always check the orientation before soldering.

• Ran out of colors

Know correct direction

I'm hand wiring a planck soon so could you explain the technique to make it work with easyAVR?
permalinkembedsavegive gold
[–]pokkuhlag[S] 1 point 7 months ago
The most important is the diode direction. This is from row to column. Most build you see here is the opposite direction. For example matt3o brownfox example is diode direction from column to row. This will not work with the current version of easy avr handwire config. The second thing is when you use a default led port. you need to define the led port to an unused port. Me and fauxsoul had the issue when you do not define it correctly, it will active a row on the wrong port. See this link for problem and solved

• Transparent is nice